top of page
RollbarMount_1

Action camera mount bracket for Roll cage

* Camera not included

A bracket for attaching an action camera to a roll cage.
It is a design that corresponds to the general 40φ bar in the FIA / JAF standard.
In addition, the installation method is devised, making it easier to install even on vehicles with small clearance from the roof.

RollbarMount

Diameter

It supports a bar of 40φ.
Please note that roll bar pads are not supported.

RollbarMount

Tightening structure

It is designed to be easy to assemble and to achieve reliable tightening, and to be easy to install and remove.

RollbarMount

Clearance

Thanks to the thin design and ingenuity of the mounting structure, it can be used for a wide range of vehicles with little roof clearance.

RollbarMount

Anti-scratch/anti-slip

It is recommended to use 1mm thick rubber or elastomer material together to prevent the roll cage from being scratched and from slipping or making noise.
Please purchase it yourself, cut it to the appropriate length and paste it. We recommend the one with adhesive.

RollbarMount

Lightweight, high rigidity

By using industrial nylon material, it achieves light weight and high rigidity.
Firmly installed, it is possible to shoot without blurring.

RollbarMount

Mounting screw

Prepare an M5 cap nut on the action camera mounting side, and an M5x40mm hexagon bolt set for assembling the fastener.

A bracket for mounting an action camera on a roll cage.
 

Designed to fit a 40φ roll cage.
There are many similar products, but this product has a particularly thin design and a devised mounting structure that greatly improves the degree of freedom in mounting.
It is a stylish design that has never been seen before.


●It is firmly fixed and holds the camera firmly even when driving on a circuit or gymkhana.
●By making it a thin design, it does not interfere with opening and closing the canopy of the NA-ND Roadster.
●Engineering nylon is used for the material, and it is extremely lightweight while achieving high durability and strength.
●You can choose from a wide variety of colors according to your preference.

* Although we have conducted sufficient tests, we are not responsible for accidents caused by improper installation.

* Customers need to prepare bolts, nuts, 1mm thick anti-scratch rubber sheet, etc. required for assembly.

* Be careful not to over-tighten the mounting screws. Over-tightening will damage the plastic parts.

*Specifications are subject to change without notice for product improvement. Please pardon.

bottom of page