top of page
ZC6_ZN6_Clutch Pedal Extension_1

Clutch Pedal extension 15mm for 86 (ZN6) / BRZ (ZC6)

*Please use genuine pedal rubbers.

Clutch pedal lifter for TOYOTA 86 (ZN6) and SUBARU BRZ (ZC6).
It is possible to improve the driving position by moving the pedal about 15mm closer to the driver than the genuine one.

​Amount of correction

​Amount of correction

By installing between the clutch pedal lever and the pedal rubber on the vehicle side, the pedal can be brought to the driver side by 15mm.

How to install

How to install

For installation, please slide it so that it covers the clutch pedal lever from the side.
After that, use the screw holes on the back of the main unit to fix it to the clutch pedal on the vehicle side. (Be careful not to overtighten.)
​It is strongly recommended to use a screw locking material together with the hexagon socket set screw.

Fixing screws

Fixing screws

Secured with an M5 x 10mm Hex Socket Set Screw.

Clutch pedal extension for TOYOTA 86 (ZN6) and SUBARU BRZ (ZC6).

By inserting it between the clutch lever and the pedal cover, the pedal moves from the genuine position to 15mm closer to the driver.
 

Since the angle of the ankle becomes loose, the fatigue of the foot when driving on street roads.

Fine adjustment of the driving position is possible. (Improvement of symptoms such as the clutch being far away when matching the brake)

It facilitates delicate clutch operation such as starting dashes and hand brake turns in sports driving.

In addition, this product can be installed on both vehicles equipped with aluminum pedals and vehicles equipped with rubber pedals.

<How to install>
*Before mounting, please prepare M5x1
0mm hexagon socket set screws separately.
1. Remove the genuine pedal cover.
2. Attach the pedal rubber to the pedal lifter in advance.

3. Slightly screw the hexagon socket set screw into the screw hole on the back in advance. (At this time, it is recommended to apply thread lock agent in advance.)

4. Insert the lifter into the pedal lever from the side, and secure by tightening the hex cap screw.

The material uses MJF method PA12GB to ensure high strength and heat durability.

Also, since it is made very lightweight, there is no adverse effect on the clutch feeling.

*Although we have conducted sufficient tests, we are not responsible for accidents caused by improper installation.
*Be careful not to over-tighten the mounting screws. Over-tightening will damage the plastic parts.
* General medium-strength screw lock materials for metals can be used.
*Specifications are subject to change without notice due to product improvement.

© 2023 by Sublime Design Japan. Proudly created with Wix.com

bottom of page